Quick-fuel-technology Blow Out Protection Kit Bedienungsanleitung PDF herunterladen

Blow Out Protection Kit Instructions

1. Remove throttle body from main body

2. Locate the power valve vacuum passage (note: small hole next to the center

throttle body screws pri. & sec.)

3. Check the drill collar height this should be 9/32” of the drill point exposed)

4. On the main body surface of the throttle body, drill the P.V. vacuum passage until

the drill collar contacts the gasket surface.

5. Remove all chips and deburr if necessary

6. Install the spring provided with the large end of the spring at the bottom.

7. Install the check ball.

8. Position the new seat in the hole and lightly tap it with a drift and small punch until it

is flush with the gasket surface.

9. Reinstall the throttle body.

P/N 99-18

1 2

Seite 1

Blow Out Protection Kit Instructions 1. Remove throttle body from main body 2. Locate the power valve vacuum passage (note: small

Seite 2

Keine Kommentare

Quick-fuel-technology Blow Out Protection Kit Bedienungsanleitung